|
cup Holder
Try making this for a cup holder- purchase a 3"X 4"ABS reducer and a white 4" test cap. Cut out the inside stop on the 3" side of the reducer. Silicone the test cap into the 4" end. Set the flat part of the test cap so that it is about 1/8 inch in from the edge of the reducer. Cut a vertical notch in the 3" end for your cup handle and you have a cup holder. With the wide bottom it is hard to turn over and works as a trash can at other times. It is not real pretty, but it works for under $5.00.
Bill
|