[thekidd]

I read Clarks Grage, I know how to do the procedure. Clarks says to get a .8mm washer and glue it to the end. Went to my local hardfware store to pick one up (along with some other nuts 'n bolts), talked to a worker an askee how do I tell if it is ,8mm tall? And he said that he didnt know, just too look for it? All he knew was the lenght and diameter, not height. What ones have you used? i had the manifold off, and a washer from the screw that holds the manifold on, does fit in the reference hole, but dont know if it .8mm though. And also, when you take the reference sensor off, there is an "8" looking washer (1 bigger hole for the sensor, and a smaller one for the mounting screw. When you do the cleance, do you put this between the bracket and sensor, or leave it out when doing clearance? Thanks guys.