[jury]

For some reason the front bumper sat about 3 inches too wide on each side, so after alot of head scatching the only option was a cut and shut job! I cut a section out of the middle, braced and then fibreglassed over the backside of the join...





The panel gaps are all over the place, especially where front wing meets door. Alot of this project has been trial and error, and sorting this area is no exception. I built up with fibreglass on the topside and marked the gap then built up on the backside. the brace bar on the back was way off so I decided to cut it off and then fabricate some brackets to attach onto the chassis, its solid and kinda looks lightweight!