|
Member 911 Anonymous
Join Date: Sep 2007
Location: Rancho Palos Verdes
Posts: 14,329
|
Quote:
Originally Posted by lr172
I wouldn't worry too much about the connector. Many believe that there is no problem pulling reference air from the engine compartment and I subscribe to this. However, you are definately wise to make sure the connection on the sensor side of the wire is not soldered or sealed so that air can enter the wire.
Good luck
|
Oh Damn!
I though I was being a good DIYer by heat shrinking and effectively making it water proof the male bullet connector to the sensor side of the connection. Crap!
OK, need to expose.
__________________
'85 Carrera Targa
Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace
PCA/POC
|