[nynor]

Originally Posted by GH85Carrera

Not even close.

I did get the steering rack and turbo tie rods done. The brake calipers are a lot cleaner, ready for rebuild and maybe ready for paint. The old wheel bearing races are out. Next up is to get the new wheel bearing races installed in the hubs. All I have to do is figure out how to do that. Does anyone have suggestions on how to get the wheel bearing races pressed into a hub? The Bentley manual says heat the hubs to 300F and use the magic wheel bearing race tool and a press. There must be some other way.

heat the hubs and freeze the races. then use a bearing drift and ball peen hammer to set the races. the races will need to spend about eight hours in the freezer, a deep freezer works best. the hubs can be heated for about an hour to get them all the way hot.