The cylinders I got with my all re-done but disassembled 3.2 have all been bored and re-plated by US Chrome. From memory I was told that US Chrome bores it oversize and then plates in a thick lining of Nickisil.
Here's the fun part, from the outside these cylinders just appear like 5 normal KS Alusil cylinders plus one Mahle Nicksil cylinder. Inside where it matters, they are all the same. (bore, material, cylinder height)
I would worry about this apparent mismatch if I were looking at the engine from an outsiders viewpoint. What would you do, if anything at all, to possibly mark the Cylinders to indicate they were re-plated?
Here's my engine rebuild thread:
http://forums.pelicanparts.com/911-engine-rebuilding-forum/515477-richards-3-2l-total-rebuild.html
Thanks,
Richard