[speedracing944]

I am so happy! I just graduated with a BS in Mechanical Engineering from UW Madison. It has been a long time dream of mine which I have been working hard to make come true. I have been in school part time for 9 years prior to going full time at UW Madison 3.5 years ago.

So far my educational lineup is;

4 year Apprenticeship in Plastic Injection Molding
Associates in Plastic Injection Molding
Bachelors of Science in Mechanical Engineering

While at UW Madison I focused on internal combustion engines and design. My major project I spearheaded was conversion of a IC engine to run on gas phase propane injection utilizing MicroSquirt engine management. In the end the engine ran well and had excellent throttle response. I was very pleased with the outcome.

I am in job search mode but have an appointment with one of my professors about a potential Graduate School position in the Engine Research department at UW Madison.

Keep an ear to the ground for me regarding a design position.

Regards,
Speedy