[Walt Fricke]

No, no. 135mm is the installed height spec.

This is engraved in my brain (and I checked with Wayne's book, which repeats the factory spec, as the brain has too much in it to trust on details some times) because of my failure to follow Tom's underlying advice back when. I just screwed them in until they bottomed, and some were too deep and I compensated with thinner washers. Others stuck out too far, and the inhex spit out the tool before torque was obtained and I fussed around with adding extra washers. Not a good show on my part, and all due to carelessness. Ignorance also, to be sure, but careless not to take the time to find the spec.

Walt