[ghnat]

Well, want to hear the whole story.... I bought a bearing race and seal driver kit on Sat. I got the bigger race installed no prob. I test fitted the disk for the smaller bearing (a tight fit) to a hot hub... The disk expanded and I could not get it out. I tried and tried. So today I went to my friends shop and used his manual mill and cut the disk in half; well just about, there were a few thousands left on each side. Then used an arbor press and viola! So the bearing installer I would have used got completely ruined... I'll heat the hub tomorrow and carefully use a punch. I wrapped it in tape tonight so I hopefully won't nick it...

I should have been done with this on Sat. The joys of DIY, and still being a novice! Maybe one day I'll learn.