[ONQRACIng]

Just started to read this excellent post, and I want to be sure I am on the right page.
I run Motec, with Bosch coils packs for twin plug, and would like to go COP if it is smart and more reliable.
I have an ignition expander off the M48 ECU, which runs to a 6 channel ignitor.
The coil packs now gets 12V from the Ignition switch, and the signals from the ignitor (6). I would like to remove the coil packs, and run COP using the same outputs from the ignitor. From what I am reading, this will work?

I am leaning towards the Kawa COP setup, two wire should be the way for me to go, I think?

Is there any negative drawbacks using these coils?