|
Caveman Hammer Mechanic
Join Date: Feb 2009
Location: Boulder Creek CA
Posts: 3,444
|
EDM,
Problem is your engine has to be out. Still would be easier and cheaper than splitting the cases. That pin will be harder than any drill you can buy, good luck post up your results.
eric
P.S. EDM is one of the only(very few) ways to remove broken taps and drills, from expensive castings and forgings.
P.S.S. I don't know if it would be possible to use a stud welder on a piece that small, but check it out. "H and S Auto Shot HSA5500 Stud Starter Welding Kit"
http://www.engineersedge.com/edm.shtml
__________________
1984 Carrera El Chupacabra
1974 Toyota FJ40 Turbo Diesel
"Easy, easy, this car is just the right amount of chitty"
"America is all about speed. Hot,nasty, bad ass speed."
Eleanor Roosevelt, 1936
Last edited by ClickClickBoom; 01-15-2010 at 04:53 PM..
|