|
Calibration report says 0,65% errormargin at 40NM (lowest) and again something like that at 200Nm.
Largest error is 0,88% at 120Nm.
I can set it lower than 40Nm and higher than 200Nm but there are no scale markings lower or higher than that.
I'm guessing that the tool is calibrated correctly between these values and that errors become larger as I go lower or higher than this range.
This is a high quality tool, so I'm not really worried.
Tomorrow I need the the camshaft tool, that I will borrow from my friend mechanic.
And I need to get my P201 adapted, I'm still disassembling the engine on the wooden palette...
__________________
Сидеть, ложь, Переворачиваться
|