Ok, let's recap, set to convert to EDIS with megajolt jr, ignition control. Nice and straight forward. But now, COP is looking good.heres what I have now plus the coil, coil wire, and shelded wire.
I have a Kow coil coming and THINK there triggered off 12v. SO, on the megajolt oitput there is 3 signals to trigger the coil (in 6cyl config.) that should trigger the COP just the same way the 6-coil pac is triggered. Only difference is where the coils are.
Am I on the right track or is the voltage too small for the coil(s)?
Megajolt is making a COP version but unknown release date. Here is a spec. sheet on the Megajolt COP:
Summary
Megajolt/COP is a Programmable Crank Fired ignition targeted for intelligent coil-on-plug modules or external igniter applications.
Capabilities
Supported configurations
Up to 8 cylinders in true coil-on-plug mode
Up to 12 cylinders in wasted spark mode
10K+ RPM capable
0.1 degree timing resolution
Features
Dual VR Sensor input
Crank Sensor + Cam Angle Sensor input
8 coil driver outputs
Soft and hard rev limit
Designed to work with commodity OEM sensors and coil packs
Initial support for 36-1 trigger wheel; other trigger wheel configurations to follow
up to 16x16 ignition map with linear interpolation
Dual, on the fly switchable ignition map support
4 User defined digital outputs
3 analog input channels
TPS, Temperature and Aux
Ignition correction for Temperature and Aux
Provision for on-board MAP sensor
On-board expansion for knock sensor module
32 bit 48Mz ARM processor
USB programming interface
Note that it works in wasted spark and sequentical.