[isocyn8]

The fuel pump when it is jumped at the relay pumps fine. It is getting good pressure and flow. It just wont pulse the injectors. I tried a friends dme that is supposed to be good, but getting the same result. I also purchased a third dme relay just in case. haha. So, with the dme relay in place fuel pump wont run, but I have spark. If bypassed at the dme relay the fuel pump runs, I have spark, but no injector pulse. I verified this with a noid light. All fuses checked. Fresh gas. different ignition switch, however not new. One thing is that I found when putting the ignition switch on is that an aftermarket alarm was hooked up at the ignition switch. I removed the alarm, and connected the wires back to their respective partners. Not really sure where to go from here..............Looking for a link to check power at the dme connectors so I can verify I am getting what I need. Any Ideas would be appreciated. Thanks guys.