[trucker677]

hey guys,

I was working on the car today trying to figure out why the tilt steering mechanism wasn't working. I figured out that the nut was on too tight and when I was backing out the nut that is attached to the square rod that goes from one side of the bracket to the other, the ball bearing fell out, has anyone had this problem with theirs before and how do you out it back in.
Do I take the nut all the way out and slide the square rod out and reinstall the spring and ball bearing in and slide it up into place and tighten it down. I didn't want to go any further without some good advice or maybe an easier way to install it. my car is a 82 928s. auto. Thanks in advance