Quote:
Originally Posted by Tobra
I have an x-ray processor for which I have built a small stand. My plan is to secure the processor to the stand, and secure the stand to a cinder block wall. The question is, how best to do so? I was thinking I would drill a few holes and using epoxy, mount some threaded stock to the wall, like wheel studs sort of, and bolt the rig to the wall.
Any thoughts or suggestions on this project?
There will be a bit of plumbing to do, also need to make the room light tight, but that should be relatively straightforward.
TIA
|
No, but I just wanted to point out that line about Europe at the bottom of your posts is wrong and quite inane, and makes you look a bit silly.