Quote:
Originally Posted by asphaltgambler
Could you guys explain / illustrate to me the wiring diagram where only 2 way cross over is used? The crossovers now are mounted under the seats
|
In my version,
You would run the FRONT RCA outs of the head unit to the ACTIVE two-way crossover (like an AudioControl or something of your choice.) The crossover has crossover point and level control for each of it's outputs.
Run the LOW outs of the crossover to two channels of the amp,
Rund the HIGH outs of the crossover to two other channels of the amp.
If your amp has a crossover built in for the SUB section then I'm assuming it is high-passing the other 4 channels also, which is good.
So, out of the crossover into the amp X4, and run a speaker out (the LOW crossover-ed one) to each MidBass,
and the other 2 channels to your passive crossovers under the seat, EXACTLY like they are already, but the Midbass portion has been removed and gone straight to the amp.
NOW, you can control the level of the midbass seperately from the mid/hi combo, either with the crossover, or the amp gain controls.
Unfortunately, this uses up two more channels of the amp, so you don't have anything for the rears, BUT if your head unit has speaker outputs, you can use them to run the rears to get some fil back there.
Sorry I think that was a little wordy.