[Rot 911]

Saw your post over on Grizzly and responded there.

Here are some other things I would look for:

Check out the cv joint boots. If they are cracked, this can allow water to get inside. This will cause rust and lead to major damage, which leads to major repair cost!

While you down there, check the oil in both differentials. Does it look milky or chocolate colored? This is a sign of water. You can also use this rule of thumb for the engine oil.

Support the front end with jack stands. Then try to move each front wheel in and out from top to bottom and side to side to check for worn wheel bearings and ball joints. Do the same for the rear.

To check for worn tie rod ends, try and move the handle bars back and forth. There should be little to no play.

Don't forget to remove the seat and check the air box for dirt and water. This is often overlooked and can be a sign of abuse or lack of maintenance should you find a dirty one.

Use a flashlight to inspect the inside of the gas tank.

Turn the lights on/off and make sure all work.

Take the atv for a spin. Does the atv start right up or is it sluggish? Try a few hard stops. Do the brakes function properly? Does it handle well? Look and listen for anything out of place.

Does the exhaust have the spark arrestor in place? National Forest and other public trails require spark arrestor's to be in place.

What about the body? Is there any damage? Cracked or otherwise damaged body parts will need replacing.