|
Had part was cutting the crest out of the key with out nicking it, I used a set of jewelers glasses (magnification) after doing it i found you should cut the crest out starting at the bottom and around the sides all the way through and leave the top un cut ( or you are working on a very small piece) then slowly grind down the back of the crest after you remove the sides.I used a cut off wheel.
any "crazy glue" type will work and just a dab will do ya.
Not sure I would use one so small on my horn but hey if it works.
the beauty of this was I had a new (used) lighter incase I messed it up. but mine matched my dash better.
take your time and it will look great
|