[bluemane500]

dude ,there are some screws on the bottom in the carpet,there are some size 10mm screws in the door pocket, one in the air vent, the panel above door pocket just pops out and slides out from behind exit handle,, exit handle has a screw in cover over handle,and where the lock spins , pop of cap with small flat head screw driver and remove either screw or 8mm nut, then spin off bezel in back of locking mechanism, large needle nose will do it,two screws at wiring harness bezel at front of door, then there are only plastic push clips holding it on pry back door panel,, slide drivers panel to right and pass door to left,, there is a retaining bracket in the corner behind the trim mldg that surrounds upper part of door,power mirror button has a disconnect plug, take off panel then be careful removing plastic , it is a moisture barrier,,, your door handle answer lies inside the door,parts are available at 928 intl