[Fishcop]

So the 69 chassis runs internal oil lines for the cooler (through the sills) and these are tricky to install if not done at the factory, so in anticipation I picked up a set of SC lines some years ago. I was just going to use "riv-nuts/nut-certs" to anchor the SC oil lines but I was advised that there is a fair load and vibration on those points when the lines are full of oil, and the sills are relatively thin steel. So I welded up brackets like the later cars use out of some spare chromoly steel







I've only go one of the mounting brackets so I had to "imagine" that three will hold the lines nice and parallel