|
Once you have turned the motor over by hand to ensure there is no mech interference and that the valves are moving properly. There is a story there.
You can crank a few times to get the oil moving and get some pressure.
When you are ready you should use the normal MFI starting sequence.
1 Lift the hand throttle
2 Turn the key and listen for the fuel pump let run 10-15 sec
3 Turn to start and let the engine crank for 10-15 sec
4 If it does not start re do steps 2 and 3.
5 You can tip into the foot feed just a bit at the end of the 15 sec of cranking but do not hold starter too long and do not pump the foot feed.
It should start just with the hand throttle.
Good luck with your new motor.
|