|
I have that jack, but before you use it there is an Alan screw on the outside of the pump that you can remove. Stick a screw driver in there and tighten the screw in almost all the way. This will allow the jack to come down slower. I bolted a 3\4 inch, 2x2 piece of plywood on the jack and I kept the motor on it the whole time. I was only doing clutch/tranny work. Take a block of wood and place it under the tranny, or a floor jack while you wiggle the tranny off. The atv jack is great because you can wheel the engine where ever you want.
One other thing, I have a 72 with SSi's so when the engine sits on the plywood it sits nice and flat.
__________________
72 911
Although it is done at the moment, it will never be finished.
Last edited by tobluforu; 07-29-2011 at 12:22 PM..
|