I bought an Ignitor Electronic Ignition (2862), on Pelican Parts Site (USA) to install on my Porsche 911T (year:1969).
My car has a MSD 6A ignition kit installed (installation scheme attached).
After reading your instructions manual (attached also) I installed it putting:
1. Ignitor black wire to original distributor green wire (that goes through MSD to Coil Negative)
2. Ignitor Red Wire Directly to Coil Positive
… and the motor do not run. I try other several ways and nothing!
I take out the ignitor and put back the points and it is all ok again.
What should I do?
Regards,
Carlos Domingos
Portugal (Europe)