I have been busy working and need to update this thread with some new pictures! I am doing some mill projects now so I need to focus (unsuccessfully at times) a little differently now.
Finished these on the lathe:
Inletting guide screws. One pair each for Mauser, Remington 700 and Winchester 70. The slots for the screwdriver is hand cut with a hack saw.
Did some more work on the action wrench (bolts were done earlier):
Not too happy about the mistake on this one. Fed the mill in the wrong direction. I will leave it for now and might remake this if time allows.
Started this today. Bolt bending block. Cut to size, clamped and .703 hole drilled followed by a step to 0.8125.
I should be able to finish this project tomorrow.