[Mericet]

Used an oxy-acetylene torch for the first time today since (I think) 1981. Had to do the top piece of the handle and fix the round nut I made to the handle. David, this is my barrel dent remover.

Handle pictures with close ups of the brazing. Of course, I cleaned these up a little.




The only thing left is to cut the anvils. Here is some pictures from start to finish. I did polish the anvils as well. Not to remove the tool marks, but to ensure there were no sharp edges on them. These pictures also show the top cross piece and the round nut that is shown on the threaded part of the handle.






Last picture shows the anvils with the 20 gauge anvil on the handle.