|
Z - you are a few days ahead of me. Congrats on a job well done. Ya I popped the left two green cam covers off and marked them, even took one of the right side off, hard to see in there but I did manage to mark that too. I'm just not going to kick myself later for not making sure after 360 degrees they return to the same place.
I really don't care what bearing I use, I don't drive the car enough to worry so if Wayne's comes out soon I'll probably use his.
Was yours a single or double row? I notices on LN site that the puller for a double row was different. They make sure to spread the load out on the engine casing so as not to crack anything. Mine is double row. I want to lock the exhaust came before I pull the cover off and check it's condition...again being careful even though I have totally removed the chain tensioners left and right.
I'll PM you about parts. Anyway good lock on the rest. My clutch kit comes in this week. I did the RMS tonight. Tomorrow I need to replace my leaky oil fill tube.
Cheers.
|