I got an MSD 6200 unit as well as a blaster 3 coil. I need some help figuring out where two of the wires go. I've got the 4 simpler ones connected, two to battery and two to the coil.
Red: Connects to a switched 12 volt source. Such as the ignition key or switch.
White: This wire is used to connect to the points, electronic ignition
amplifier output or to the Yellow wire of an MSD Timing Accessory.
When this wire is used, the Magnetic Pickup connector is not used.
These are the instructions I've been looking at:
http://www.jegs.com/InstallationInstructions/100/121/121-6200.pdf
I would really appreciate it if someone could post a picture of these wires connected in a 944 NA engine bay.
Also, the "White" wire mentioned above looks more yellowish than white on my 6200. And the "Orange" wire that's supposed to go the the +ve coil is no different than the "Red" wire referred to above. The Red and White wires mentioned above are in the same sleeve on my unit.
Once again, thank you.