Next step was to fit the slide stop. This is by EGW and I bought the over sized version which is .003 over sized. In hindsight, the .200 would have saved me some time because the frame was made to exacting tolerances. The stop had to be taken down to .200 to fit snugly.
Here are the ultralight sear, disconnecter, and hammer from Cylinder and Slide. Very nice peices. The pins for each took minimal sanding to get to fit tightly.
The hammer strut had to be installed by hammering in the pin.
Here is the engagement at half and full cock positions. The sear face angles are spot on out of the box.
