[Mrmerlin]

sand down the TC and spray it with some rust inhibitor paint,
mask off the cone that fits into the flex plate use antiseize grease on the snout when refitting ,
Mask the mounting pads and the input to the trans front pump .

for the vibe damper drill 2 small holes in the TT to fit a pop rivet and put one pop on either side of the damper,
this way it wont slide around down the road .
if the rubbers are loose get some glue and reglue them to the damper,
make sure the rivets are long enough to catch the damper.
OR use sheet metal screws with bolt type heads to screw into the TT after the damper is fitted

Nice work and photos