|
I've seen the Garretson hand fabricated aluminum pipe and cast aluminum Kokeln pipe for that but neither are made anymore.
Some guys have gone to a muffler shop and had a piece of cheap mild steel exhaust pipe that fits in the smaller hose swedged out to fit the 930 or 965 rubber elbow hose at the other end. That will work just as well and cost less. Then paint it black so it doesn't rust and looks good.
You could also weld it onto the end of the steel 930 down pipe and not use a silicone or rubber hose and clamps to connect it there. Doing that you can also weld on a hose fitting or bung for a 25-32mm recirculating blow off valve and then use the origonal 930elbow hose instead of a 965 hose with the 25mm hose fitting on top, if you want.
Lots of ways to do it.
|