[simon996]

Thanks guys! It's currently got a fan heater and a dehumidifier going 24/7 which seems to have made a big difference to things. The mould is now all gone, but some staining remains.

My biggest question at this stage is regarding the electrics (surprise, surprise!) I think the immobiliser is pretty much shot. Unfortunately, a couple of resistors (about 1.5mm long) on the PCB have come lose. I've got one of them, but the other is nowhere to be found. By the looks of it, the fuse on the immobiliser board blew, so I was quite hopeful about it maybe functioning again, until closer examination revealed the resistor issue. It and the DME have been thoroughly dried and cleaned and I'm planning on finishing off cleaning and checking the electrics this weekend and attaching a battery, just to see where I am.

Am I right in thinking that if I get hold of a matched DME, immobiliser and key head, I might be in business? Will I still need to get things coded if it is a full set?

I'll keep this thread updated with progress.