|
Its a relay. To what? Two spades on right are the coil. The single far left is com and the other two would be either NO and NC
To test: measure resistance across the two right terminals, if its the coil and its not failed you will get a number,
test continuity across switch, the single left terminal and the two middle terminal: one should read continuity, the other not.
If you ID the coil and its good apply 12 volts, then measure continuity across switch terminals. They should reverses position, close to open etc.
Last edited by romad; 06-18-2012 at 01:00 PM..
|