[Brando]

A question to the Pelican brain trust. Anyone here that can, or knows a good Stainless steel welder? I'm looking to get a small bit of cutting and fabrication done. Hopefully no parts added...

I have an extra "T" pipe that I would like to run between the top balance tubes between both mufflers. I need this "T" pipe welded to and joining the original "T" pipe in a clean fashion. Some cutting and welding, no custom bends or fabrication needed (I hope).

Is there anyone in the Orange County area who can accommodate inexpensively? I can disassemble the exhaust but I would prefer to take the whole car and only pull off parts as needed to maintain alignment.

Anyone know someone who can do this affordably?

Thanks!