Quote:
Originally Posted by RWebb
thx - I have to admit I have not been up to PDX in a few years
a cabinet-maker here would charge me $80 for his table saw cut - this place is full of artists, ya know...
I think I will have a shot at the sideways router table method -- I've used the router off & on for 12 years at least now...
this doesn't seem more dangerous than other router operations -- or does it??
|
$80? You can almost buy a new drawer for that much.
What the total height of the drawer? Set the distance between the cutter and the fence and run it through. Make sure you feed against the rotation of the bit, if not it
WILL get you. it should be safe and not too hard to do.