[Don LaVance]

I am all for change but need some clarification on two points before I mess things up.
1. do I use the .025 (0.63mm) for the go clearance feeler gauge?
and the .030 (0.75mm) as the no go clearance feeler gauge ?

Or, is it ment to use the much smaller .003 0.08mm as a no go?

or something else entirely.
I understand that the normal clearance on the tappet/valve stem approach would be .004 or 0.10mm.

Also am I going to need longer feeler gages to do it the backside procedure.
Thanks in advance. I don't want to do this and worry about it later.