|
Registered
Join Date: May 2000
Location: Los Alamos, NM, USA
Posts: 6,044
|
Some ideas:
Blockage (perhaps partial) in a new camtower oil line that is limiting oil flow to cams. Was any silicone rubber or RTV sealant used in your engine?
On number six, did you tighten a cylinder stud nut or a camtower to head stud nut? If the later, you may have put the camshaft into a bind.
What type of oil filter did you use?
Was the sump screen and cover plate reinstalled in the proper orientation? If not, the oil pump pickup tube may be pushed upward putting the oil pump in a bind.
Good luck, Jim
|