The car had AC that is being replaced with the 993 condenser. Needed to cut out the hump and put a flat plate in.
Here it is as it started
Here it is with the panel out...sort of an awkward location at the rear as there are to layers of sheet metal there, the crossmember (upper) and the the pan itself.
Cut up some nice galvanized sheet metal, did a bit of hammering to replicate the curve that is there and mig welded it in place. I was going to gas weld it so that I could planish the metal smooth, but found out that my oxy/acetylene hoses had a split in them (thankfully the oxy side), so I need to buy a new set of hoses before I do anything with that particular source of heat
