[K Sykes]

All parts from a 1980 SC USA model. All removed as a result of backdating heat, switching to EFI and taking out AC. All prices exclude shipping. Can take pics of all, describe in more detail and willing to test mechanical or electrical parts if there is a way to do that.

- CIS “brain” - $100
- CIS Harness - $50 (oxy sensor plug is cracked and power wires are cut with about 6” out of the plug to the brain)
- AAR $100 – works well
- Behru spark plug wires $50 – the ones with the braided steel sleeves – put on when the engine was rebuilt – have about 10k miles on them SOLD
- Cruise control brain - $75
- Cruise control vacuum cylinder $25 – up near the hot air blower drivers side
- Fuel Distributor - $175
- Metering plate and assembly $50
- CIS “snorkel” $25 (the rubber thing that connects to the throttle body and the metering plate)
- Front “tow hooks” 25$– Clean and painted with POR 15 – didn’t fit after my ER suspension updateSOLD
- Air conditioning stuff:
- Receiver/dryer $30 -
- Front condenser $20
- Engine lid condenser $20
- Heat exchanger (smugglers box) $20 – needs the icing tube and perhaps some soldering – also have the fan and top and bottom enclosure that it goes in $35. Fan runs well.
- Plastic heater blower tube – this is the corrugated plastic airway that attaches to the left side of the heater blower and runs back to the heat exchanger.
- 14 pin connector have both sides – car side has about 2” of wire attached, Car side is open and I have all the wires that go to the engine, but it’s a “bag of wire” at the moment