Quote:
Originally Posted by Green993
Hmm, this is a conundrum, what to do? I'm guessing it's gonna be 4 to 6 hours at least because of the heating required. That's if I don't remove the p/c's - just gently lift them away from the case and get the torch in there. Then I have to clean out the old loctite, etc..
Henry, would you say the .15mm is enough to cause the issue you address above. If so, I really need to fix this.
|
If your head stud install hieght is greater than the desired amount based on your head and cylinder dimensions you can adjust the measurement with a thicker head washer.