Quote:
Originally Posted by MBAtarga
yes- yellow item is a transformer.
|
The yellow transformer still emits a wee buzzing noise but with the rear cover on the electric panel it is not audible from the front of the oven.
I was going to test the output volts as Zeke mentioned as the info is started on the side of the unit but once the joint was identified, just focused on that.
I wonder if it was heat or the buzzing that broke the joint loose.
Quote:
Originally Posted by Zeke
Apparently the consensus there would have you/me use no flux. ................
|
I used flux and if it did not help it sure did not hurt.
Quote:
Originally Posted by dhoward
In the case of a cold/broken joint, I'll generally remove the old solder with braid or a 'solder sucker', then resolder with rosin-core solder.
|
There was hardly any old solder to deal with. All I did was heat the pin and it was "gone" around the base. I just used the solder the electronics store suggested I buy. Don't believe it is cored. Came in a plastic tube that is long gone.
Now it looks like this:
