|
Registered
Join Date: Apr 2009
Location: Cape Vincent, NY
Posts: 841
|
If the case was recently machined to flatten out the spigots then I would have to say it may be the rods are not all the same length. new bushings and an offset honing will take care of that. Check the spigots with a straightedge if you want to ensure machining was right. Would suck if was machined wrong and you got the rods rebushed to only have same problem.
__________________
1968 911S "Leona"
Air goes in and out, blood goes round and round, any variation on this is a bad thing.
|