|
Back from Beyond
Join Date: Nov 2004
Location: Alberta, Canada
Posts: 2,697
|
I hope you don't read this until after you get a good night's sleep but WSM states that rod bearings must be replaced in the event mixing of oil and coolant occurs. There's a lot of info on this and it's not hard to do. First things first though, and congrats getting the oil cooler removed.
BTW, what were your compression numbers warm? I re-read your first post and those numbers look okay. Maybe #2 is carboned up a bit. Then why the clean plug? A little coolant in the cylinder would bump compression...
Last edited by Slam; 08-11-2013 at 11:06 PM..
|