|
Okay, trying to keep the frustration down I did as advised and disconnected the battery for a bit. Now the brake lights are working again (dash tail light indicator also out) but still getting the flashing pressure light because the new rear switch seems to have a small leak. When I replaced both switches I just tightened them with a wrench. Are they to be fully seated real tight? Can they be turned too far in? Is there a specific amount of turns? I just removed the old ones without counting turns, etc. I didn't apply any sealer to the threads, I figured the blue stuff they came with was sealer. Although frustrated on this, it is not toward any of you, to the contrary, I appreciate all advice-Thanks!
|