I took the balance shaft cover off, removed old seals and sleeve, cleaned surfaces and reinstalled new sleeve and seals. I then put the cover back on. However, the sleeve is sticking out a bit too far. I haven't tightened any bolts yet. Will tightening the bolts pull the housing back far enough for the key to be inserted?
Don't want to tighten anything if I screwed anything up. The picture below does look pretty close to the pic I took after loosening the housing bolts. Hoping that tightening the bolts will bring the sleeve back far enough.
Your feedback is appreciated.
Below is the pic before I took off the cover.
