|
911 Ride Height Settings:
Usually, the rear is set to factory specs first and then the front is
adjusted so that the front end is 1" lower.
The rear is measured as follows: The center of the rear torsion
bar to the ground is measured. The center of the wheel to the
ground is measured. The difference between these two
measurements is then calculated. For Euro height, the difference
should be 16mm, and for USA height the difference should be
37mm. (to make this measurement a little easier, you can
measure ground to bottom of torsion bar tube and add 1/2 inch),
__________________
I don't always talk to liberal arts grads, but when I do, I tell them Big Mac and small fries!
1974 911 RUF Clone ('85 3.2; '86 915)
1974 914 ('87 3.2L & 915 transaxle)
2005 Boxster (Base car) Guards Red.
|