[redstack]

Next will be trying to adjust the linkage using these directions from Isf911

"Just follow these instructions from the Tech Info Center. I have used this technique a few times now and it works. You might have to play around a bit to get it perfect.

Shift Linkage - Adjustment

1. Remove the cover plate on the tunnel, behind the front seats.

2. Place gearshift in neutral.

3. Loosen the shift rod clamp. Turn the shift rod (by grasping the coupler) to the right, as seen in the direction of driving.

4. Move gearshift lever to the left until it touches the stop, and move it fore-and-aft until the lower section is vertical when viewed from the side (the fore-and-aft adjustment can be modified to suit the driver, provided sufficient length of the shifter rod remains inside the clamp).

5. Lightly tighten the clamp.

6. Check if equally long travel is evident in gears 1-4, and that 5th and reverse can be easily engaged. Correct as necessary.

7. Tighten the clamp securely.

8. Shift into 5th gear, and check the shift rod for rotational play.

A definite (slight) amount of play must be evident."
__________________