On board. hence one of the other reasons for the engine drop. rocker shaft seals, adjust valves, turbo valve covers with new gaskets. All new vacuum hoses and intake sleeves too. rebuild the distributor, new wiring harness to install, oil pressure warning lamp switch, oil cooler thermostat o ring, oil cooler seals, s shaped rubber hose, new oil return tubes, cam housing covers, flywheel seal and the main shaft pulley seal, cis fuel injection seal/gasket. Hopefully that takes care of the oil leaks
I will also check the flexible oil cam lines to be sure they are good otherwise I will change those out as well. Am also going to do the rear wheel bearings, and rebuild rear calipers. (front end including turbo tie rods control arms, wheel bearings, brake calipers rebuilt, new rotors, ball joints and sway bar bushings already done. And still more to do
Good clean fun!