Quote:
Originally Posted by Niles
Would it be possible to repair your gauge cluster by soldering wires to bridge the break - i.e. solder one end of the wire to the copper trace on the cluster and the other end of the wire to the copper on the broken tab for each broken path?
|
Somewhere Here I read about using " PIN Connectors " Not sure what pin Connectors are but would assume you soder them in then just connect ? Sounds simple > So perhaps just take your cluster to a laptop repair place and have them solder in pin Connectors in to the CU Board . now the other end ( your Wireing )
that requires a on site solder job
Can someone post some Pic's of these connectors perhaps .
Yes the Whole Connection area is poorly made .