[AirtekHVAC]

Removed and Disassembled the FD again this morning. Found that I did not have the center assembly aligned well with the housing. Figures. I also found that I somehow "rolled" 3 of the rings and they were cut/damaged. Cleaned it all up and reassembled with replacement orings and copious amounts of MMO....making sure I was lined up properly, and putting the center assembly in the inverted top half thus watching each oring slide into place.....hope it got it this time. Will install this afternoon......hope it works....

Also drained all the fuel out of my motor through the oil drain plug. Got about 5 gallons out.....motor should be clean....

Refilled with oil, and drained all back out again. Installed new oil filter, and going to refill oil sump after lunch.....

On a side note, I have disassembled and repaired my MacBook Air...the battery swelled up and busted......works on charger only, battery will be here Tuesday, which means once I get this FD sorted, I can edit pictures and try to do a proper write up!